Hi I want to generate a signal as a load follow input signal for 80%-50%-80% at 10% per minute for a nuclear power plant control system on simulink? I would be glad for help because i am stucked at this stage?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
KaMATLAB
el 1 de Abr. de 2020
Comentada: KaMATLAB
el 1 de Abr. de 2020
The signal is attached. Thank you
2 comentarios
Respuesta aceptada
Birdman
el 1 de Abr. de 2020
Run the attached model. I used Signal Builder block to create the input signal.
13 comentarios
Birdman
el 1 de Abr. de 2020
In the attached figure explanation1, you see that you can set the T and Y value of that specific point by either changing the value in T and Y edit field, or by just simply dragging that specific point.
In the attached figure explanation2, you can create a new piece of line by simply dragging upwards or downwards the circled line and then again, you can set its starting and end points.
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!