Issue on Unbalanced Load Flow on Simscape Power System
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Augusto Janssen Harger da Silva
el 13 de Ag. de 2020
Comentada: Augusto Janssen Harger da Silva
el 27 de Ag. de 2020
Everytime that I try to calculate a tri phase load flow on a model that contains a synchronous machine, i get this error on Matlab Command Window: ‘Matrix close to singular or badly scaled’
However, the Balanced Load Flow works perfectly, for the same model.
Any idea how to solve this?
2 comentarios
Joel Van Sickel
el 17 de Ag. de 2020
When you say tri phase load flow, do you mean load flow on an unbalanced system? Which load flow tool are you using and can you share your model?
Respuesta aceptada
Joel Van Sickel
el 24 de Ag. de 2020
Hello Augusto,
the issue is likely with the model. It is possible that your model is 'stiff' making it hard to simulate. You could try adding snubber resistors to your motor.
This example can be modified to work with unbalanced load flow. https://www.mathworks.com/help/physmod/sps/examples/initializing-a-5-bus-network-with-the-load-flow-tool-of-powergui.html
Here is an file with the model above set up for unbalanced load flow working in 2020a. If you have an older verison you can modify the example to switch it to unbalanced and see it working with a synchronous machine.
Regards,
Joel
2 comentarios
Joel Van Sickel
el 24 de Ag. de 2020
Editada: Joel Van Sickel
el 24 de Ag. de 2020
ignore that comment, change your angle values to this: [0 -120 120]
Más respuestas (0)
Ver también
Categorías
Más información sobre Electrical Sensors en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!