pulse disturbance signal generator
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
KaMATLAB
el 15 de Sept. de 2020
Comentada: Jon
el 16 de Sept. de 2020
Hi Please can anyone help on how to generate a pulse disturbance to test the robustness of my second order sliding mode control system. My system runs fine for 10,000 seconds. I need to apply pulse distrubance to test the robusteness. However, I could only add pulse disturbace that run the entire time of the simulation time which is 10,000 seconds. I believe disturbance should just run a fraction of the entire simulation time. for instance for 100s out of the 10,000s simulation time. Please how do i generate such pusle disturbance that would not run the entire simulation time. I want it to run for may be 100 seconds or 200s of the 10,000 seconds of the simulation time.
thank you
0 comentarios
Respuesta aceptada
Jon
el 15 de Sept. de 2020
How are you running your simulation? Is it in Simulink?
In Simulink you can use a From Workspace block to create an arbitrary signal. Use this to create your desired disturbance and connect it appropriately in your diagram to apply the disturbance.
6 comentarios
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!