Problems with idnlgrey object simulation
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi everyone,
I am trying to identify the parameters of a system using a non-linear greyBox object. My system is defined as a state-space and the estimation, run by means of 'pem' command, seems to give good results.
After the estimation process, I use the command 'compare' to have a look on the results with respect to the measured data, and this results good as well.
The problem appears when I simulate the greyBox object on Simulink. The outputs it gives are completely different from the ones given by 'compare', altough I use the same input data.
Why does it happen? Which outputs should I trust more?
Thank you very much.
0 comentarios
Respuesta aceptada
Arkadiy Turevskiy
el 15 de Feb. de 2013
Editada: Arkadiy Turevskiy
el 15 de Feb. de 2013
This issue was addressed several times previously, here is a link to the earlier question that was answered alerady. You need to set the initial states correctly. Take a look at this function for doing that.
HTH.
Arkadiy
Más respuestas (0)
Ver también
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!