Borrar filtros
Borrar filtros

Antenna Array Designer Dot Indexing Error

2 visualizaciones (últimos 30 días)
galaxie3jhu el 7 de Mzo. de 2021
Editada: Sindhu Karri el 11 de Mzo. de 2021
Hi, I'm trying to run the Antenna Array Designers base case, just a rectangular dipole with no backing at 2400MHz, and when I press the 'Accept' button I get an error that says 'Dot Indexing is not supported for variables of this type'. My entire workflow is I open antenna array designer, press the plus for 'new' which opens a new antenna designer screen, and then I just put in 2400MHz as my frequency, press 'accept', and then I get that error. I didn't change any other settings. Further the screen before and after pressing accept is greyed out (ie, no plots) if that's at all relavant. Any ideas about how to resolve this issue?

Respuestas (1)

Sindhu Karri
Sindhu Karri el 11 de Mzo. de 2021
Editada: Sindhu Karri el 11 de Mzo. de 2021
I have tried to reproduce the issue on my end, but I didn't get any such error. I recommend you to go through the command window log, to find the exact cause of the error, or else you can also try by closing the exsisting App session and opening the App again, continue with the same procedure to see if the issue still exists.


Más información sobre Phased Array Design and Analysis en Help Center y File Exchange.




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by