How to program an epwm interrupt in Simulink for a TI-F28379D Controller?
32 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Benjamin Hoepfner
el 11 de Mzo. de 2021
Hi,
I would like to program a Controller and for that I need to interrupt or suppress the epwm generation. I use Simulink to program the Controller and I use the epwm blocks to define all specifications (pwm with A/B Mode - one output is switched on when the other is switched off and vice versa).
The aim is to switch switch off all epwm outups with a specified signal.
Thanks a lot. Benjamin
1 comentario
Respuesta aceptada
Benjamin Hoepfner
el 27 de Mzo. de 2023
Editada: Benjamin Hoepfner
el 27 de Mzo. de 2023
8 comentarios
tcagdas
el 29 de Mzo. de 2023
Editada: tcagdas
el 29 de Mzo. de 2023
Thank you very much for the all suggestions. After changing delays sampling time, system still produced PWMs. The newly generated PWMs are different from the ones before I activated my trip zone. It is not performing any of the forced operations. When I run the system in the simulink, the output of the boolean block produces values for different sampling times as in the figure. Could the system still be generating PWM because it produces a continuous stream of 1s and 0s? Also, when I tried using 0 instead of a constant 1, I still saw the same PWM patterns. Even, if I choose the "no action" option, it still produces the same PWMs.
Best regards.
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!