Problem with Section 7.1 Task 5 of Simscape onramp

229 views (last 30 days)
玄人 市川
玄人 市川 on 5 May 2021
Commented: Amanullah S on 4 Dec 2021 at 15:59
Although I correctly configured the model blocks and parameters accordingly to the directions, the training evaluation said my output did not match the answer. It prevents me from proceeding to the next task.
Here I attach two snapshots of the evaluation plot of Section 7.1 Task 5 where the problem occured.
The first picture shows comparison of the signals spanning to the end time (10sec). It looks to me exact agreement between the requirement and my signal, but it indicates slight discrepancies in the beginning of simulation (from 0 sec to around 1.0 sec) shown by the red dots. Due to these errors, the evaluator says my signal is incorrect.
The second picture zooms into the details of the red dots. It looks to me my signal has a slight delay to the answer.
I confirmed that my setup is consistent with the directions and the results unchanged even after several retries from the beginning of Section 7.1.
I am wondering if there is another parameter to be adjusted, which is not explicitly directed.
Can I have your help for solving this problem?
  6 Comments
Amanullah S
Amanullah S on 4 Dec 2021 at 15:59
Thank you I too strucked and rectified after giving priority as low

Sign in to comment.

Answers (2)

Orkhan Alikhanov
Orkhan Alikhanov on 26 Sep 2021
It only worked for me after I set priority to "low" in the "Variables" tab of "Rotational electromechanical converter" block.
  8 Comments
玄人 市川
玄人 市川 on 7 Nov 2021
Thank you Orkhan. Hmm.. as the other people advised to me, changing the priority to "HIGH" only worked for me.

Sign in to comment.


Joel Van Sickel
Joel Van Sickel on 18 Aug 2021
I am pasting Lianna's comment here as it is the solution.
Lianna Cubias on 7 Aug 2021 at 9:16
Figured it out! Finally!
Do tasks 1-5 as instructed. All that is correct. Before running the model in Task 5 try this:
Check the settings on the "Rotational electromechanical converter" block that your "ideal rotational motion sensor" is connected to. Go to the "Variables" tab, check the override box for "Angular velocity" and set priority to "high". Everything else, leave it the way it is. Then run the model. This worked for me because I was having this exact problem.
  15 Comments

Sign in to comment.

Products


Release

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by