Trapped air in fluid

2 visualizaciones (últimos 30 días)
Adam
Adam el 27 de Sept. de 2013
Respondida: Yifeng Tang el 19 de Ag. de 2022
Hello,
I am curious to the effects of the trapped air parameter.
I am using an ideal pressure source pumping flow into a dead ended system.
I have used values of 0.04 (I assume 4%),0.004, 0.0004, 0.00004 and 0.
The simulation for 0 gives very smooth results in analysing the harmonic of the system.
The issue I have is when I reduce the amount of trapped air (starting at 4%) the results actually get more erratic to the point where the pressure readings at the dead end read a constant negative pressure.
I was wonderings if I was doing anything wrong because I would have thought as the air was reduced the results would tend to the zero value.
Thank you.
Adam

Respuestas (1)

Yifeng Tang
Yifeng Tang el 19 de Ag. de 2022
The entrained air affects how the bulk modulus (hence also density) changes as a function of the pressure. More air will make the fluid more "compliant" at low pressure. See the plot below, generated from theIsothermal Liquid Properties (IL) block.
For the hydraulic domain, the entrained air has a similar effect. The 3rd equation on this doc page shows how the bulk modulus changes with pressure and air fraction.

Categorías

Más información sobre Upgrading Hydraulic Models to Use Isothermal Liquid Blocks en Help Center y File Exchange.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by