How to deploy the interface model to SD card of Xilinx Zynq ZCU102 kit so that it will run everytime I power up my hardware ?

I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.

I followed the example "Getting Started with Targeting Zynq UltraScale+ MPSoC Platform".

But when doing the step "Run the software interface model on Zynq ZCU102 hardware", I found that the deployed software will not effective anymore after the hardware power off and on again. "Monitor & Tune" or "Bulid, deploy &start" buttons has no difference on this power off and on case.

So how can I do to make the ARM executable still be effective and run automatically after hardware power off and on?

Answer 1

[JT Ferrara]

Please check out this MATLAB Answers post on this topic:

https://www.mathworks.com/matlabcentral/answers/474175-how-do-i-deploy-an-arm-software-executable-from-a-simulink-model-to-my-zynq-board-to-run-in-standalo