how to run a MATLAB model through GUI
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
i need to run a MATLAB model from GUI ,i had used sim command but i cannot see the simulation time , i need to see the simulation timing. I used following command "set_param(gcs,'SimulationCommand','start')"but when i run from GUI model run but i cannot see the scope waveform.can u suggest me how can i run a model from GUI and can see simulation percentage or timing
0 comentarios
Respuestas (1)
Zack Peters
el 25 de Oct. de 2013
Hi Milan,
If you save a model with the scopes open and then close the model, then the next time that you open that model, the scopes will open as well.
When you start the model via set_param you will get a full view of the model's simulation time at the right side of the model's status bar as well as continuous updating of the scopes.
You can see from executing the following code in the command window (try to simplify by taking the GUI out of the equation):
open_system('vdp')
set_param('vdp','SimulationCommand','start')
~Zack
Ver también
Categorías
Más información sobre View and Analyze Simulation Results en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!