photo

LO


Last seen: 21 días hace |  Con actividad desde 2024

Followers: 0   Following: 0

Estadística

  • First Answer

Ver insignias

Feeds

Ver por

Respondida
PAPR (Peak to Average Power Ratio) of OFDM(Orthogonal Frequency Division Multiplexing)
Yes, the Peak-to-Average Power Ratio (PAPR) in Orthogonal Frequency Division Multiplexing (OFDM) is affected by the choice of mo...

21 días hace | 0

Respondida
BER of OFDM QPSK modulated
Hello! To calculate the Bit Error Rate (BER) for OFDM with QPSK modulation, you can adapt the existing BER codes for OFDM 16-QA...

23 días hace | 0

Respondida
Modulating of OFDM signal
To modulate an OFDM signal to a higher frequency (e.g., 2 MHz) in MATLAB Simulink, you can follow these steps:Steps in Simulink:...

23 días hace | 0

Respondida
(Code) How to generate the DSB-SC using message signal (tone modulation)
Here's an example of generating a Double Sideband Suppressed Carrier (DSB-SC) signal using a message signal (tone modulation) of...

23 días hace | 0

Respondida
How to generate a DSB-SC signal?
To generate a DSB-SC signal for t∈(−0.05,0.05)t \in (-0.05, 0.05)t∈(−0.05,0.05) with a carrier frequency of 500 Hz and plot the ...

24 días hace | 0

Respondida
how do I Create the DSB-SC modulating signal with carrier frequency = 1 MHz. and Plot the spectrum of the modulating signal?
To create a DSB-SC modulating signal with a carrier frequency of 1 MHz: Modulating Signal (m(t)):m(t)=Am⋅sin⁡(2πfmt)m(t) = A_m ...

24 días hace | 0

Respondida
In Simulink, can the Local IP port of the Raspberry Pi UDP send block be set to send from a specific IP port?
In Simulink, the UDP Send block for Raspberry Pi allows you to specify the local IP address and port from which the data will ...

5 meses hace | 0

Respondida
How to receive UDP packet in Simulink?
Receiving a UDP packet in Simulink involves using the "UDP Receive" block, which is part of the Instrument Control Toolbox or ...

8 meses hace | 0