photo

Philipp X.


Con actividad desde 2013

Followers: 0   Following: 0

Mensaje

Estadística

All
  • Thankful Level 1
  • Knowledgeable Level 1
  • First Answer
  • Solver

Ver insignias

Feeds

Ver por

Pregunta


R2013a 64 Bit + Stateflow + Simulink + MinGW + Gnumex = working?
Hi, I wonder if I can use the combination of mentioned programs under Windows 7 64Bit? Does Stateflow work? I have serious...

alrededor de 11 años hace | 0 respuestas | 0

0

respuestas

Respondida
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...

alrededor de 11 años hace | 0

Pregunta


Measure reaction forces in joints and bearings
Hi! I built a model in SimMechnics 2G. It seems to work quite good :) Is there a way to measure the reaction forces or the...

alrededor de 11 años hace | 1 respuesta | 0

1

respuesta

Respondida
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...

alrededor de 11 años hace | 1

| aceptada

Pregunta


More information about assembly (or why is something not assembling)
Hi, I wonder if there are more tools in SimMechanics 2G than the Explorer who simply states: Joint x ist bad. For example, so...

alrededor de 11 años hace | 1 respuesta | 0

1

respuesta

Pregunta


How to interface Stateflow charts with Bus signals
Hi, In my model a stateflow chart has a lot of inputs and outputs. Is it possible to feed a bus signal directly into or ou...

alrededor de 11 años hace | 2 respuestas | 0

2

respuestas