I need help with Application compiler
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hello everyone
I NEED SOME HELP
I am trying to build Standalone App from Matlab as shown in the figure. When I run my code, it is ok.
However, it had some problems after I used Application Compiler to build a standalone app.
The app couldn't open and this message appeared: "The specified module could not be found"
I don't know how to solve this problem.
I think this happens with the path that I try to load the .dll library.
Could you please help me to solve this problem?
Thanks very much
2 comentarios
Walter Roberson
el 16 de Sept. de 2021
Using cd() is not recommended. Changing the path is not recommended. You should be using ctfroot() and make your library directory relative to the directory the source code is in, so that it will automatically be built into the archive in the right place.
Respuestas (1)
Image Analyst
el 17 de Sept. de 2021
If you shipped your library and had the user put it into some specific folder, then specify that folder fully, from the drive letter. Or else you're going to have to figure out from the relative path, which is not easy or trivial since the executable is not where you think it is (long story).
0 comentarios
Ver también
Categorías
Más información sobre MATLAB Compiler en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!