Borrar filtros
Borrar filtros

How do I stop "Simulation Data Inspector"?

38 visualizaciones (últimos 30 días)
Homero Noboa
Homero Noboa el 23 de Mayo de 2017
Comentada: Stefanie Schwarz el 24 de En. de 2022
I was analyzing some model a while ago and I enabled the Data Inspector, but now I'm not interested in that feature anymore. However, now, every time I run my model, Simulink shows a pop up window:
No data to record
Model 'myModel' has been configured to send logged workspace and MAT-file data to the Simulation Data Inspector. Based on the current model settings, there is no logged data in a format supported by the Simulation Data Inspector. Consider updating the model to stream signals to the Simulation Data Inspector.
How do I prevent this to happen? I don't want to record any data.

Respuesta aceptada

Shubham Srivastava
Shubham Srivastava el 26 de Mayo de 2017
Editada: Stefanie Schwarz el 24 de En. de 2022
To resolve this error message in R2016b and ealier and stop recording any data, go to the Simulink Data Inspector (SDI) Icon in the Simulink Editor tab. If logging Workspace data is turned on, you should see a small record button over the SDI Icon. To disable logging, select the drop down arrow next to the SDI icon and click again on the "Send Logged Workspace Data to Data Inspector" to disable it.
Regards,
Shubham
  2 comentarios
爱媛 钱
爱媛 钱 el 4 de Mzo. de 2021
Sorry, I can find "Send Logged Workspace Data to Data Inspector" in ver2015a, but can't find it in ver2019a. Where is it.
Stefanie Schwarz
Stefanie Schwarz el 24 de En. de 2022
The option "Send Logged Workspace Data to Data Inspector" was removed from the SDI icon in R2017a, however it appears to be equivalent to the (still existing) model parameter "Record logged workspace data in Simulation Data Inspector":
That being said, disabling this option will only prevent SDI from loading workspace data (which is what caused the above error message for the asker), but there maybe still be many other reasons why SDI is active for your simulation. One obvious reason is logging signal data, another could be that you are logging Output or States data in 'Dataset' format as explained in this answer:

Iniciar sesión para comentar.

Más respuestas (1)

Frank Zhou
Frank Zhou el 15 de Mayo de 2019

Categorías

Más información sobre Analyze Simulation Results en Help Center y File Exchange.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by