Plotting a spiral in MATLAB knowing the start and end points and number of turns?
124 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Alec Lothian
el 23 de Nov. de 2018
Comentada: km meenu
el 19 de Jul. de 2020
I found a code and was able to modify it into the following code to creaet a spiral that starts at the point I want it to but I can't seem to get it to end where I want it to and have the desired numer of turns.
t = 1:5000;
u = .0265;
r0 = 10;
r = r0 +u*t;
omega = .005;
phi0 = 3*pi/2;
phi = -omega*t+phi0;
x = r .* cos(phi);
y = r .* sin(phi);
plot(x,y)
grid on;
1 comentario
Jacob Shulman
el 23 de Nov. de 2018
where do you want it to stop? you'll have to just figure out the value of t at that point. currently you have 5000 values of t. To shorten the spiral, shorten the array t.
Respuesta aceptada
Jos (10584)
el 23 de Nov. de 2018
This does the job (for an integer number of turns)
% given values
pos = [8 4 ; % startpoint
2 7 ] ; % endpoint
nturns = 3 ; % number of turns (integer value)
% engine
dp = diff(pos,1,1) ;
R = hypot(dp(1), dp(2)) ;
phi0 = atan2(dp(2), dp(1)) ;
phi = linspace(0, nturns*2*pi, 10000) ; % 10000 = resolution
r = linspace(0, R, numel(phi)) ;
x = pos(1,1) + r .* cos(phi + phi0) ;
y = pos(1,2) + r .* sin(phi + phi0) ;
plot(x,y,'b-',pos(:,1),pos(:,2),'ro-') ; % nturns crossings, including end point
7 comentarios
km meenu
el 19 de Jul. de 2020
I have a code of galaxy model and spiral line code how i draw the spiral line in the spiral arms of the galaxy
Más respuestas (0)
Ver también
Categorías
Más información sobre Startup and Shutdown en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!